Brown Felt Furniture Levelers with T-Nuts, 1/4" Thread (Set of 4)

Level furniture without scratching the floor.

These levelers have a nylon foot capped with high-density felt, so you can level a table or cabinet right on a hardwood floor without leaving marks.

Felt that stays put.

The base has two parts: a hard espresso-colored plastic section and a grey high-density felt pad that's permanently epoxied on. The felt resists compressing, so the piece stays level.

Threaded, not screwed.

Each leveler has a 1/4" threaded stud, 1" long, that runs into a T-nut. Every leg adjusts from 0" to 3/4" and carries 100 lbs., or 400 lbs. for the set of 4.

Installs in under 10 minutes.

Drill a 5/16" hole, 1" deep, at each corner. A wrap of tape on the bit makes a handy depth gauge. Tap in the T-nuts with a hammer, screw in the levelers and back them out until the piece sits level. Keep each leg in line with the cabinet sides for the most strength, and use an adjustable square to hold the same setback from the front.

Where to use them.

Tables, stools, grandfather clocks and most wood cabinets that need leveling.

Specifications.

• Thread: 1/4" threaded stud, 1" long
• Adjustment: 0" to 3/4" per leg
• Foot: nylon with a high-density felt base, epoxied on
• Load rating: 100 lbs. per leg, 400 lbs. per set of 4
• Mounting hole: 5/16" diameter, 1" deep

Here's what you get.

• 4 Brown felt levelers
• 4 T-nuts