Heavy Duty Leveler Legs with Lock Nuts, Black (4 Pack)

Built for the bench that gets dragged around.

Workbenches don't sit still. They get scooted, shoved and pulled across the floor, usually fully loaded. These black levelers were made for that kind of life.

The ledger that fights back.

Here's something most people never think about. The foot sits out past where the leveler is screwed on, so every bit of weight tries to pry the leveler off sideways, like someone bouncing on the end of a diving board. Our Heavy Duty ledger reaches farther in, and it has screw holes on the bottom as well as the side. Screw up into that 2x4 or 4x4 and the prying stops cold. Bench legs give you plenty of wood to bite into, so use it.

A foot that stays where you point it.

No snap-on cap here. The base is a nylon disc permanently bonded into a steel shell, so there's nothing to pop off. The steel ball at the end of the shaft rides in a nylon socket, so the foot tilts up to 20° to sit flat on a sloped garage floor, and it holds that angle instead of flopping around. No rattles, either.

Two ways to adjust.

Can reach it from above? Use the included 5mm hex wrench. Only got room underneath? There's a hex built into the base of the shaft, so the included open-end wrench does the job from below. Because sometimes you just can't get to the top, am I right?

Lock nuts, of course.

Level it, snug the lock nut up against the housing, and vibration won't walk it out of adjustment.

Dressed for the shop.

Black enamel over zinc-plated steel. It looks sharp and holds up to shop life.

Pro Tips.

• Lift the workpiece a little with a pry bar and spin the shafts by hand to get close. Then, once the workpiece is sitting on the levelers with its full weight, fine-tune with the hex wrench (or the open-end wrench from below).
• Drive the bottom screws first, then the side screws. The bottom ones pull the ledger tight against the wood, so the side screws go in square.

Specifications.

• Load rating: 600 lbs. per leg
• Housing: .080" steel, zinc-plated with a black enamel finish
• Ledger: extended, with screw holes in the side and bottom
• Shaft: 3/8" diameter, built-in hex at the base
• Adjustment: 3/16" to 2-1/4"
• Foot: 1-1/4" diameter, nylon base bonded into a steel shell, steel ball in a nylon socket, swivels up to 20°
• Screws: #10 x 1-1/8" pan head, black, take a #2 Phillips bit

Here's what you get.

• 4 Heavy Duty leveler legs with lock nuts
• 24 #10 x 1-1/8" pan head screws (6 per leg)
• 1 5mm hex wrench
• 1 open-end wrench

Not sure which one you need?